Our Gloss Metallic vinyl wrap has a smooth, high-gloss finish and is crafted from the high-grade polymeric multilayered calendared vinyl film, complete with air release channels. Gloss Metallic wrap is durable and has good conformability; it’s stretchable enough to wrap around every edge and recessed area of your vehicle with ease. Gloss Metallic also uses a safe solvent polyacrylate adhesive, easy to install and gentle on car paint.
Conformable polymeric material with stable colour pigments. Suitable for full car wrapping (or any other smooth or curved surface).
The thickness of the film: 0.16mm
The thickness of film with release liner: 0.32mm
Note: Products that have "HD" letters in their SKU (product code) are with the plastic release liner (high-gloss films)
Type of film: High grade polymeric multi-layered calendared vinyl film with air release channels
Colours: Fierce red, Passionate Purple, Acid lime, Coral Peach, Ocean Wave, Amber Brown, Crystal Silver, Columbia Blue, Sea Turquoise, Cerulean Blue, Ocean Green, Mexican pink, Kelly Green, Golden yellow
Width & Length: Standard roll size - 1.52m*18m (59.8"* 708,6", 4.98ft*59ft, 1.66yd* 19,6yd)
Series: 190 series
Adhesive: Henkel solvent-based acrylic adhesive, transparent, ultra-weather-resistant, viscosity 1000~3000cps, thickness 12 μm dry
Storing period (shelf life): 2 years if stored in +10°C to +20°C, relative humidity 50%, in original package, away from direct sunlight, clean and dry place
Avg. indoor life: 4 years when followed rules of application and usage
Avg. outdoor life: 3 years when followed rules of application and use
Application: from +17°C to +25°C, usage from -55°C to +65°C
Dimensional stability: shrinkage less than 4%
Plastification: between 27%-35%
Breaking Strength: 22.7 N/10mm (Average) Test Method: ASTM D3759/D3759M-057.4 N/10mm (Average)
Light Ageing in UV Exposure: Test Method: ASTM D4329-13 Cycle A & ISO 105-A02:1993/Cor.2:2005, Test result: 5, Pass; Exposure cycle: ASTM D4329-13 cycle A, Lamp type: UVA-3408h UV at (60±2.5)°C BPT, 0.89 W/ (m2•nm)@340nm, 4h condensation at (50±2.5)°C BPT, Exposure duration: 49h
Recommended application tools: Squeegee, buffer, knife, masking tape, heat gun, magnets, gloves, IRR thermometer, IRR heater
Application method: Standard methods for calendered films. No overstretching. Post heating
Post-heating temperature: 100°C
Cure time: 24 hours above 10°C
Aftercare: PH neutral, Avoid wax or solvents
Tools: soft squeegees with buffers
The protective cap should be peeled off before installation.
Important note: The images, colours, and finishes on the screen are approximate. For the real representation of the product, always check the colour swatch. Rolls from the same production LOT number should be used for completing a wrap job as a slight batch to batch variation of colour may occur. The film may scratch during the application or a day in and out use. The scratching of the film is not covered by the warranty.